Overview; Installation; Evolution® Smart Connect; Installing The Remote Batteries - Toro EVOLUTION Series Manual

Overview

Setup button
Left arrow
Setup
USB Cover
(future use)
Down arrow
Cancel
Cancel button
LCD Screen
Up arrow
Mode
PWR (Hold)
Power
button
Right arrow
Enter
Enter button

Installation

EVOLUTION® Smart Connect®
Please see the install sheet that came with the Smart Connect
device.

Installing the Remote Batteries

The remote receives power from a 9-volt battery (not included).
To install the battery:
1. Remove the three
(3) screws from the
battery cover on the
back of the remote,
then remove the
battery cover.
2. Snap the battery onto
the battery clip and
place the battery into
the compartment.
3. Reinstall the battery
cover with the three
screws.
Battery
3