Siemens SICHARGE UC Operating Instructions Manual page 94

SICHARGE UC Dispenser UL | Operating Instructions
Alarm code Description
15 Incorrect CP status
16 The input frequency is out of range.
17 The "Stop Charging" button on the HMI
has been pressed.
18 Vehicle error: Battery temperature
prevents charging
19 Vehicle error: The electric vehicle
changes its position.
20 Vehicle error: Failure of the charging
plug interlock
21 Vehicle error: Battery malfunction
22 Vehicle error: Charging current
difference
23 Vehicle error: The charging voltage is
outside the permissible range.
24 Vehicle error: Incompatibility of the
charging system
25 ... 43 Power converter error
94
Error handling
The CP status "C" has been lost during the charging process.
The loss of the status may be caused by noise due to bad
wiring between the output of the charging station and the
vehicle's charging socket. Bad wiring inside the vehicle can
also cause the loss of status due to noise.
• Measure the frequency of the alternating current
The charging station is set to an input frequency of 50/60 Hz
±10%.
No fault. The alarm indicates that charging has been stopped
by pressing the button on the HMI
The vehicle battery is too hot or too cold for charging.
• Bring the vehicle to a standstill
The vehicle has not recognized the charging plug inserted
into the charging socket or the charging plug cannot be
disconnected.
Any unrecoverable fault or unrecoverable fault state of the
vehicle battery.
The vehicle has detected that the charging station cannot
provide an output current that meets the actual voltage
requirement. Therefore, the vehicle has stopped the
communication session.
The vehicle has detected that the vehicle battery voltage is
below or above the normal voltage range.
The vehicle has determined that the charging station is
incompatible.
• Insert the charging plug into the plug holder
• Start the charging station in manual mode
• If the error does not appear, try a new charging process