Installing And Removing The Battery Pack - DeWalt DCBL722 Instruction Manual

20v max axial blower
Hide thumbs Also See for DCBL722:
Table of Contents

Advertisement

Installing and Removing the Battery Pack

(Fig. F)

WARNING:
battery, make certain the speed lock lever
off position to prevent switch actuation.
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
 5 
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. F
Proper Hand Position (Fig. G)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 
3
.
Fig. G
Before removing or installing
2
 6 
into the tool handle, align the
6
5
To reduce the risk of serious
To reduce the risk of serious
3
Switching ON/OFF (Fig. A, H)

WARNING:
product firmly when switching on.

CAUTION:
is in the
self or bystanders.
To turn the blower ON, ensure the speed lock lever
in the off position and depress the trigger switch
To lock the blower ON, push the speed lock lever
forward, as shown in Fig.  H. The blower runs at higher
speeds as the lever is moved further. The speed lock
lever can also be pushed forward to start the blower
without needing to first depress the trigger switch.
To turn the blower OFF, release the trigger switch
or pull back on the speed lock lever and return it to its
off position.
Fig. H
Use (Fig. I)

CAUTION:
self or bystanders.

CAUTION:
hearing protection. Wear a filter mask if the operation
is dusty. Use of gloves, long pants and substantial
footwear is recommended. Keep long hair and loose
clothing away from openings and moving parts.
Install the battery pack
Hold the blow tube approximately 7 inches (180 mm)
above the ground, turn the blower ON and using a
sweeping motion from side to side, advance slowly
keeping the accumulated debris/leaves in front of you
as shown in Fig. I.
Fig. I
English
Use both hands to grip the
Do not point unit discharge at
Do not point unit discharge at
Always wear safety glasses and
 6 
into the battery housing.
 2 
is
 1 
.
 2 
 1 
and
2
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents