Do you have a question about the DCBL722 and is the answer not in the manual?
Questions and answers
Ken Vagen
February 4, 2025
Three dewalt batteries all fully charged. Unit runs for short time then stops. Unit will blow for a second then stop again. This cycle happens with all three batteries.
1 comments:
Mr. Anderson
February 10, 2025
The DeWalt DCBL722 unit may stop running after a short time despite using fully charged batteries due to a defective battery pack or an overheating issue. The manual indicates that if a battery is too hot or too cold, the charger will pause charging until it reaches an appropriate temperature. If the battery is faulty, the charger will refuse to charge it. Additionally, foreign materials causing a short circuit in the charger or battery contacts could also lead to similar issues. Checking the battery status, ensuring proper ventilation, and inspecting for debris in the battery terminals may help resolve the problem.
This answer is automatically generated
DONNA BOWERS
March 17, 2025
where is the off button , the manual stated to turn off before removing the battery to recharge it
1 comments:
Mr. Anderson
March 17, 2025
To turn off the DeWalt DCBL722, either release the trigger switch or pull back on the speed lock lever and return it to its off position.
This answer is automatically generated
Christian
March 29, 2025
Aloha
We have many DeWalt items. And we really like most of them.
The DCBL722 Brushless Blower make a very loud noise when we turned it ON,
what can we do to eliminate the very loud noise???
Help, my home is on a very quiet street
Mahalo
Christian
Page 1
Instruction Manual Guide D’utilisation Manual de instrucciones DCBL722 20V Max* Axial Blower Souffleur axial 20 V max* Soplador Axial 20 V Máx* If you have questions or comments, contact us. Pour toute question ou tout commentaire, nous contacter. Si tiene dudas o comentarios, contáctenos.
Page 2
English Definitions: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
English 20V Max* Axial Blower DCBL722 IMPORTANT SAFETY WARNING: Never allow children, INSTRUCTIONS persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge or people unfamiliar with these instructions to use the READ ALL INSTRUCTIONS BEFORE...
English Do not point unit discharge at self or bystanders. • To reduce your exposure to these chemicals, wear approved safety equipment such as dust Do not use to blow explosive dust, or in areas where • masks that are specially designed to filter out air contains explosive dust such as coal, grain, or other microscopic particles.
English BATTERIES AND CHARGERS Contents of opened battery cells may cause • respiratory irritation. Provide fresh air. If symptoms The battery pack is not fully charged out of the carton. persist, seek medical attention. Before using the battery pack and charger, read the safety instructions below and then follow charging WARNING: procedures outlined.
Page 6
1-800-4-D WALT (1-800-433-9258) or visit our (AWG or American Wire Gauge) for safety. The smaller website www.dewalt.com. the gauge number of the wire, the greater the capacity The RBRC® Seal of the cable, that is, 16 gauge has more capacity than 18 gauge.
English NOTICE: ampere rating. If in doubt, use the next heavier gauge. The Under certain conditions, with the lower the gauge number, the heavier the cord. charger plugged into the power supply, the charger Minimum gauge for Cord sets can be shorted by foreign material. Foreign materials Total length of Cord in Feet of a conductive nature, such as, but not limited to, Volts...
English The compatible charger(s) will not charge a faulty battery between 65 °F and 75 °F (18 ° – 24 °C). DO NOT charge pack. The charger will indicate faulty battery pack by the battery pack below +40 °F (+4.5 °C), or above refusing to light. +104 °F (+40 °C).
English 2. Slide the concentrator onto the tube Intended Use 3. Push down until the tabs on both sides of the This cordless handheld blower is designed for professional tube engage the locking holes in both sides of the blowing applications. concentrator DO nOT use under wet conditions or in presence of 4.
English Installing and Removing the Battery Pack Switching ON/OFF (Fig. A, H) (Fig. F) WARNING: Use both hands to grip the WARNING: product firmly when switching on. Before removing or installing CAUTION: battery, make certain the speed lock lever is in the off position to prevent switch actuation.
Blow dirt and dust out or tool abuse. For further detail of warranty coverage and of all air vents with clean, dry air at least once a warranty repair information, visit www.dewalt.com or week. To minimize the risk of eye injury, always call 1-800-4-D WALT (1-800-433-9258).
Need help?
Do you have a question about the DCBL722 and is the answer not in the manual?
Questions and answers
Three dewalt batteries all fully charged. Unit runs for short time then stops. Unit will blow for a second then stop again. This cycle happens with all three batteries.
The DeWalt DCBL722 unit may stop running after a short time despite using fully charged batteries due to a defective battery pack or an overheating issue. The manual indicates that if a battery is too hot or too cold, the charger will pause charging until it reaches an appropriate temperature. If the battery is faulty, the charger will refuse to charge it. Additionally, foreign materials causing a short circuit in the charger or battery contacts could also lead to similar issues. Checking the battery status, ensuring proper ventilation, and inspecting for debris in the battery terminals may help resolve the problem.
This answer is automatically generated
where is the off button , the manual stated to turn off before removing the battery to recharge it
To turn off the DeWalt DCBL722, either release the trigger switch or pull back on the speed lock lever and return it to its off position.
This answer is automatically generated
Aloha We have many DeWalt items. And we really like most of them. The DCBL722 Brushless Blower make a very loud noise when we turned it ON, what can we do to eliminate the very loud noise??? Help, my home is on a very quiet street Mahalo Christian