Mitsubishi Electric Lossnay LGH-50RVS-E Handbook page 39

( 3 ) GM assembly
[1] Remove the control box cover. → See (2) [1].
[2] Check that LED4 on the control circuit board is OFF,
and then disconnect the geared motor (GM) connector
(CN12) from the power circuit board.
Assembly precaution
After connecting the GM connector
(CN12), tuck the excess leads into the
main unit.
[3] Remove the maintenance cover A and maintenance cover B. → See (2) [3] and [4].
[4] Remove the filters and inner cover. → See (2) [5].
[5] Draw the Lossnay cores out from the unit. → See (2) [6] and [7].
[6] Open the snap-in cable clamps (LGH-50RVS-E: two pcs., LGH-80RVS-E/LGH-100RVS-E: three pcs., indi-
cated by ) and remove the GM cable from them.
[7] Remove the screws (two PTT screws 4×6, indicated by
Push in
the leads.
), and remove the GM assembly from the main unit.
GM cable
─ 39 ─
Control circuit board
GM assembly
CN12
Power circuit board