Mitsubishi Electric PZ-43SMF-E Installation Manual

1310875HJ7101
Lossnay Remote Controller
This remote controller is to be connected to a Lossnay unit to allow that unit to be started and
stopped, and to allow selection of the ventilation mode and of the fan speed.
furthermore, the subsequent installation must be performed correctly and safely in accordance
contractor.
1 Safety Precautions
This symbol denotes what could lead to serious injury or death if the Lossnay
WARNING
remote controller is misused.
- Never modify or repair by yourself.
Contact your dealer for repair.
- Do not move or reinstall the product by yourself.
representative.
to apply external force of the cables to the connector.
-
CAUTION
the Lossnay remote controller is misused.
- Do not use the product in special environments.
sprays are used frequently.
- These substances can compromise the performance of the unit or cause certain components
- Do not supply 220-240 V to the remote controller. The maximum is 12 VDC.
- Do not install in any place at a temperature of more than 40°C (104°F) or less than 0°C (32°F)
malfunctions.
- Wire so that it does not receive any tension.
-
- Failure to do so could
-
- Failure to do so could cause injury.
2 Component names and supplied parts
Parts name
PZ-43SMF-E
Roundhead cross slot screws M4×30
Operation Manual
(1) Field-supplied parts
Parts name
Thin metal conduit
Cable cover
Putty
Molly anchor
Remote controller cable
(2) Field-supplied tools
- Knife or Nipper
- Miscellaneous tools
4 Installation
Note:
-
- Do not install the remote controller directly onto electrically conductive objects such as metal
plate that has not been painted.
(2) Installation space
Leave a space around the remote controller as
remote controller.
Qty.
1
1
1
1
Qty. Notes
1 Not required for direct wall installation
Necessary
Necessary
Necessary
Reasonable
Necessary
Necessary
16 ( 5/8 ) 16 ( 5/8 )
8
6 ( 1/4 ) 20
( 13/16 )
10
( 3/8 )
or less
54 ( 2-1/8 ) 44 ( 1-3/4 )
Minimum required space
around the remote controller
30 (1-3/16)
30 (1-3/16)
120 (4-3/4)
installation method.
1
wall.
2
tube with putty.
Note:
cable access holes with putty.
3 Prepare the bottom case of the remote controller.
4
Connect the
cable.
16 (5/8)
6 (1/4)
with putty.
Note:
5 Install the bottom case.
Be sure to secure two places of the bottom case.
hole with putty.
Refer to 1
Roundhead cross
slot screws
Remote controller
cable
Refer to 4
Note:
30 (1-3/16)
6 Cut out the cable access hole.
Wall
Conduit tube
with putty.
Remote
controller cable
Top case Bottom case
Insert the sheathed
part of the cable
inside the case,
and then secure
the cable.
must be seen
Remote controller cable
Route the cable behind
the remote controller
Remote controller
cable
Wood
Refer to 4
screws