Table of Contents
Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting unit(s).
4.
Shut off the machine and remove the key.
Description
No parts required
Slope sensor
Carriage bolt (1/4 x 2 inches)
Lock nut (1/4 inch)
Spacer
Slope sensor decal
Fuse (2 A)
No parts required
Qty.
–
Prepare the machine.
1
2
2
Install the kit.
2
1
1
Install the fuse.
–
Calibrate the sensor.
2
Installing the Kit
Parts needed for this procedure:
1
Slope sensor
2
Carriage bolt (1/4 x 2 inches)
2
Lock nut (1/4 inch)
2
Spacer
1
Slope sensor decal
Procedure
1.
Raise the platform. Refer to the traction unit
Operator's Manual.
2.
Remove the plastic bulkhead behind the seat.
3.
Install the slope sensor to the machine frame
with 2 carriage bolts (1/4 x 2 inches), 2 spacers,
and 2 flange nuts (1/4inch) to secure the slope
sensor to the machine frame
2
Use
(Figure
1).
Advertisement
Table of Contents
