Toro MB TX 2500 Operator's Manual page 59

7. Prepare the fuel system.
A. Add a petroleum-based fuel stabilizer/conditioner to the fuel in the tank. Do not use
an alcohol-based stabilizer (ethanol or methanol).
B. Run the engine to distribute conditioned fuel through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and drain the fuel tank using a pump-type
syphon.
D. Start the engine and run it until it shuts off.
E. Choke the engine.
F. Start and run the engine until it does not start again.
G. Dispose of fuel properly. Recycle as per local codes.
Do not store fuel containing stabilizer/conditioner longer than the duration
recommended by the fuel-stabilizer manufacturer.
8. Prepare the engine.
A. With the spark plugs removed from the engine, pour 2 tablespoons of engine oil into
the spark plug holes.
B. Place a rag over the spark plug holes to catch any oil spray, then turn the key to
crank the engine and distribute the oil inside the cylinder.
C. Install the spark plugs.
Note:
9. Check and tighten all fasteners. Repair or replace any worn, damaged, or missing parts.
10. Paint all scratched or bare metal surfaces with paint available from your Authorized
Service Dealer.
11. Store the machine in a clean, dry garage or storage area. Remove the key from the
ignition switch and keep it in a memorable place.
12. Cover the machine to protect it and keep it clean.
3451-705A
Do not install the wire on the spark plugs.
IMPORTANT
Page 6–2 Storage: Storage Safety