Replacing A Fuse - Toro MB TX 2500 Operator's Manual

Battery Service (continued)
4. Charge the battery for 1 hour at 25 to 30 A or 6 hours at 4 to 6 A.
Do not overcharge the battery.
5. When the battery is fully charged, unplug the charger from the electrical outlet, and
disconnect the charger leads from the battery posts.
6. Install the battery onto the machine and connect the battery cables.
Note:
occur.
Installing the Battery
1. Place the battery on the platform and secure it
using the 2 wing nuts
.
2. Install the positive battery cable
battery.
3. Install the negative battery cable
battery.

Replacing a Fuse

The electrical system is protected by fuses and requires no maintenance. If a fuse blows,
check the component or circuit for a malfunction or short.
3451-705A
g003792
Do not run the machine with the battery disconnected; electrical damage may
and the securing rod
IMPORTANT
to the
to the
g185906
Page 5–14
Positive battery post
Negative battery post
Red (+) charger lead
Black (-) charger lead
Maintenance: Electrical System Maintenance