Advertisement
5.1
JIG Mode
The following remote control units are required to set and cancel JIG mode.
For setting : a remote control unit attached to product.
For cancellation : JIG remote control unit (part number : PTU94023B)
Remote control unit
attached to product
When the main body is set to JIG mode and when the main body is under JIG mode, the remote control unit attached to product op-
erates only in "Remote Control Code 1". Since main body is in "Remote Control Code 3" when it is shipped and just after its batteries
are changed, "Remote Control Code 3" needs to be changed to "Remote Control Code 1."
< Changing Remote Control Code >
(1) The switch of remote controller is switched to the DVD side.
(2) Press the numeric button "1" of the remote control unit while pressing the "SET UP" button of the remote control unit. Then,
press the "ENTER" button, and then release the "SET UP" button.
(3) Press the "PLAY" button of the main body for five seconds or longer while the main body is in stand-by mode, and a current
remote control code of the main body is displayed in FL indicator of the main body.
(4) While keeping the state of (3), press the "STOP" button of the remote control unit toward the main body.
(5) The code that was set by the remote control unit blinks for 5 seconds, before the code is set to the main body. When the FL
indicator changes to "DVD 1", it shows that the Remote Control Code has been changed to "1".
TROUBLESHOOTING
(1)
(2)b
"(2) a-c" shows the order of pressing the buttons.
(2)c
(4)
HDD
DVD
S TA N D B Y / O N
(2)a
SECTION 5
JIG remote control unit
JIG remote control unit
[Data transmission]
Set the data code,
and then press the
"
"
3
button.
(3),(5)
RAM/RW
DVD 1
Custom code
43:A Code
53:B Code
Initial mode
6F:C Code
7F:D Code
Data code
(3)
PR
NAVIGATION
GUIDE
ENTER
PUSH-OPEN
PR
(No.YD089)1-11
Advertisement
