Advertisement
5.7
Initialization to the factory shipment state
When the initialization is operated, internal information changes as follows. It is essential to obtain the client's permission before the
operation.
• All DVD library is all deleted.
• All the DVD initial settings go back to the initial status.
(1) Set to the JIG mode.
(2) Transmit "43-6F" with the JIG remote control unit.
(3) FL indicator displays "FACTORY", and changes to "CHECK OK" after blinking for a short while.
(4) Pull out the power code from the wall socket.
(5) The JIG mode is forced to cancel at the same time with the initialization, check whether the JIG mode is canceled by plugging
the power code into the wall socket again. (The colon ":" in time display should be continuously ON, not blinking.)
If the JIG mode is not canceled, transmit "43-9D" with JIG remote control unit to cancel the JIG mode.
5.8
Setting after the drive unit replacement
When the drive unit is replaced, it is necessary to set a region code. Service drive units for replacement are not set for any region
code, and they are in an indefinite condition.
Make sure to set region code after attaching the drive unit to the main body.
Without the setting of the region code, discs that have regions cannot be played back.
5.8.1 Creating a region setting disc.
Please check the details of the region setting disc creation method by JS-NET.
(1) Download the region setting file from JS-NET.
(2) Write the region setting file into CD-R. Pay attention in the following points when writing the file into CD-R.
• Make sure to write in "Disc at Once".
• Set the file compatibility to "ISO9660 format". (ROMEO, JOLIET are disapproved).
If the writing method is not correct, the normal setting cannot be performed.
5.8.2 Setting the region
(1) Set for the JIG mode, and switch the main body to "DVD".
(2) Load the region setting disc on the tray, and then close the tray.
(3) When the disc reading operation is completed, transmit "43-70" with the JIG remote control unit.
(4) FL indicator changes to "UPDATE". Remove the disc as the tray will open for a few seconds.
(5) Then, check whether the FL indicator is "REGION 2", and then close the tray.
(6) Turn the power OFF, and pull out the power code, and then plug the power code in again.
(7) Cancel the JIG mode.
5.9
When it is displayed in FDP, "RESETTING"
When the following operations are carried out, "RESETTING" is displayed in the FDP of the main body.
(1) When the "POWER" button and the "STOP" button of the main body are pressed at the same time
(2) When the code "9B" is transmitted to the main body by using JIG remote control unit in JIG mode.
(3) When transmission failure occurs between the main CPU and the DVD host CPU due to defect.
If "RESETTING" is displayed in the FDP after the power code is plugged into the outlet, check the followings.
• The peripheral circuitry of each microcomputer
• Whether the wire between the DVD drive and the board is properly connected
• Whether the wire between the main board and the digital board is properly connected
1-16 (No.YD089)
Advertisement
