Advertisement
5.1
JIG Mode
Please refer to "DR-MH300BE, DR-MH300BEK,DR-MH300SE,DR-MH300SEF,DR-MH300SEK, DR-MH300SER,DR-ED400SE
(issue number : YD089)" about this section.
5.2
Displaying SYSTEM INFO
Please refer to "DR-MH300BE, DR-MH300BEK,DR-MH300SE,DR-MH300SEF,DR-MH300SEK, DR-MH300SER,DR-ED400SE
(issue number : YD089)" about this section.
5.3
Updating the firmware of the main body
Please refer to "DR-MH300BE, DR-MH300BEK,DR-MH300SE,DR-MH300SEF,DR-MH300SEK, DR-MH300SER,DR-ED400SE
(issue number : YD089)" about this section.
5.4
Updating the firmware of the drive unit
Please refer to "DR-MH300BE, DR-MH300BEK,DR-MH300SE,DR-MH300SEF,DR-MH300SEK, DR-MH300SER,DR-ED400SE
(issue number : YD089)" about this section.
5.5
Taking out a disc
< Method 1 >
There is a forced tray eject mode with electrical operation.
(1) Right after plugging in the power code (while "PLEASE" and "WAIT" blink alternately and it is displayed), keep pressing the
OPEN/CLOSE button of the main body.
(2) Remove the disc as the tray is ejected in a short while.
(3) The tray closes automatically at about five seconds.
< Method 2 >
When < Method 1 > can not remove the disc, the tray can be ejected mechanically without turning the power on.
(1) The DVD drive unit is detached from the main body.
(2) The part a on the reverse side of a drive unit is made to slide in the direction of an arrow with a screw driver etc.
(3) As the tray ejects a little, pull out the tray manually.
1-12 (No.YD089B)
SECTION 5
TROUBLESHOOTING
Part a
Advertisement
