Table of Contents
Advertisement
9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in fitter plate with loosened screws
in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw
previously removed and securely tighten
all 3 screws with a Phillips screwdriver.
[Refer to diagram 1.]
If you wish to use the LED light kit,
remove 1 screw from fitter plate and
partially loosen the other two screws.
Connect WHITE wire from motor housing
to WHITE wire from LED light kit. Connect
BLACK wire from motor housing to
BLACK wire from LED light kit. Be sure
molex connections snap together securely.
[Note: If you will NOT be using the LED
light kit, do NOT connect the molex.] Align
slotted holes in LED light kit with loosened
screws in fitter plate. Twist LED light kit to
lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
[Refer to diagram 2.]
Locate slots on glass shade and align with
nodules on inside of LED light kit.
push up on glass shade and turn
RIGHT (clockwise)
until it slides completely
into place.
[Refer to diagram 2.]
If you do NOT wish to use the light,
slots on metal cover and align with
nodules on inside of
push up on metal cover and turn to the
RIGHT (clockwise)
until it slides completely
into place.
[Refer to diagram 3.]
CAUTION:
Do not connect the LED light
kit if you do NOT wish to use the light.
Gently
to the
locate
LED light
kit. Gently
motor housing
fitter plate
screw
diagram 1
motor housing
nodules
slots
diagram 2
diagram 3
page 8
motor plate
molex connections
molex
connections
LED light kit
glass shade
metal cover
Advertisement
Table of Contents
