Table of Contents
Advertisement
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely. Slide canopy
cover up to canopy, aligning rounded part of
slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Locate 10 blade arm screws and lock washers
in hardware pack. Slide a blade arm into one
of the sqaure holes in the side of the motor
housing, making sure to align the blade arm
holes with the motor screw holes, and then
attach blade arm with lock washers and blade
arm screws. Before securing screws
permanently, repeat this procedure with
remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
canopy
screw
motor
housing
lock washers
and blade
arm screws
page 7
hanging bracket
screw
canopy cover
blade
attachment
screws
and washers
blade
blade arm
square hole
Advertisement
Table of Contents
