Table of Contents
Advertisement
10. Light Kit Assembly (Optional).
If you wish to use your fan WITH the light kit, Remove
3 screws from light kit fitter. Locate BLUE (or BLACK)
and WHITE wires in the switch housing labeled FOR
LIGHT KIT CONNECTION. Remove and discard plastic
that holds these 2 wires together.
Connect WHITE wire from switch housing to WHITE
wire from light kit fitter. Connect BLUE (or BLACK)
wire from switch housing to BLACK wire from light kit
fitter. Be sure that molex connections snap together
securely.
Align holes in light kit fitter with holes in switch
housing. Attach light kit fitter with 3 screws that were
previously removed. Securely tighten all screws.
Attach glass shades to light kit fitter with
thumbscrews provided in one of the hardware packs.
Do not overtighten thumbscrews as glass may crack or
break.
Install 4 candelabra base 40 watt max. bulbs
(included)
Important: When replacing bulbs, please allow
bulb(s) and glass shade(s) to cool down before
touching.
11. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull chain
directly opposite the reverse switch. Start at the OFF
position (no blade movement). First pull will set the fan
to HI. Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will re-set the fan to
OFF setting. Test light kit with the pull chain in the
middle. (Refer to diagram 1.) If fan and/or light do
(does) not function, please refer to "Troubleshooting"
section to solve any issues before contacting Customer
Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chains extensions provided or custom pull
chain extensions (sold separately) to ends of pull chains.
switch
housing
thumbscrew
glass
shade
bulb
diagram 1
diagram 2
page 7
motor housing
molex
connections
thumbscrew
light kit fitter
pull chain
extensions
diagram 3
diagram 4
reverse
switch
Advertisement
Table of Contents
