Huawei BTS3900 GSM Commissioning Manual page 10

About This Document
This describes how to commission the BTS3900.
4 Starting the Site Maintenance Terminal System
Before starting the Site Maintenance Terminal, firstly, set the IP address of the Site Maintenance
Terminal PC; secondly, connect the Site Maintenance Terminal PC to the BTS; finally, log in
to the Site Maintenance Terminal.
5 Running the BTS3900 Software
This describes how to load the correct software version to the boards or modules in the BTS3900
cabinet and how to activate the board software.
6 Checking the Transmission and Networking
The purpose of checking the transmission and networking is to ensure that the BTS3900
transmission cables and hardware are correctly installed. The items to be checked consist of the
transmission between the BBU and the DRFU, the transmission between the BBU and the BSC,
and the consistency between the actual networking and the data configuration.
7 Commission the Antenna System
This describes how to commission the antenna system. You must check whether the antenna is
connected properly and whether the Voltage Standing-Wave Ratio (VSWR) is normal. If an
RET antenna is configured, you must commission the RET antenna.
8 Checking the Operating Status of the BTS3900
To ensure the normal operation of the BTS3900, you need to check the status of the BTS3900
LEDs, check the alarm information displayed on the Site Maintenance Terminal System, and
perform loopback tests on the boards.
9 Commissioning the BTS3900 Services
This describes how to test whether the BTS3900 supports CS services and PS services by using
an MS.
10 Checking the BTS3900 Environment
This describes the various environment alarms of the BTS3900. It also describes how to perform
environment monitoring for the BTS3900.
11 FAQs for BTS Commissioning
This describes the fault symptoms and cause analysis in the BTS commissioning.
12 Data Sheet for Commissioning
The commissioning data sheet is used to record the process and result of the commissioning.
Conventions
1. Symbol Conventions
The following symbols may be found in this document. They are defined as follows
2 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
BTS3900 GSM
Commissioning Guide
Issue 03 (2008-07-15)