September 2004
Selecting Mass Flow Units
Procedure Options
2-4
]
1. Press [
and [ ] to select the desired mass flow units for the
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS.
]
2. Press [
and [ ] to select the desired time units for the mass
flow rate display and press [ENTER].
]
3. Press [
and [ ] to select the desired number of digits to the
right of the decimal point in the mass flow rate display and press
[ENTER].
]
4. Press [
and [ ] to select the desired units for the totalized mass
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS.
]
5. Press [
and [ ] to select the desired number of digits to the
right of the decimal point in the totalized mass flow rate display
and press [ENTER].
After completing the above steps, the user program returns to the
Channel PROGRAM window. Do one of the following:
To continue entering "quick startup" data, press [ESC] once and
•
proceed to Step 3 in the following section.
•
To continue regular programming, refer to Appendix A, Menu
Maps, to navigate to the desired menu.
To leave the user program, press [ESC] three times.
•
Programming Site Data