Download Print this page

Hitachi StarBoard FX Series Setup Manual page 25

Hide thumbs Also See for StarBoard FX Series:

7. Trouble Shooting

(1) SX-2000WG+ is not displayed for initial settings (wired connection)

(a) Check the LED

If SX-2000WG+ is working with the wired mode, the bottom LED is solid green.

If not, please check if the hub and the cable are not faulty, and make sure the

connection and restart SX-2000WG+ (disconnect and connect the power cable). If the

LED is not still solid green, the unit might be faulty and contact the support for

SX-2000WG+.

(2) Connection not established (wireless connection)

(a) Check the LED

If the settings for wireless connection are configured properly, the LED is flashing green.

If not, please disconnect the network cable and restart the SX-2000WG+ (disconnect

and connect the power cable).

If not, please disconnect the network cable and restart the SX-2000WG+ (disconnect

and connect the power cable).

If the LED is not still blinking green, please go back to Section 3 and set up again.

If still not, the unit might be faulty and contact the support for SX-2000WG+. Please

refer to "Device Server Setup CD" for support center information.