Vehicle Speed Sensor Service; Speed Sensor Location - Polaris RANGER 1000 2020 Service Manual

CHASSIS / BODY ELECTRICAL
2. Verify AWD hub coil is functional. Test the AWD hub
coil using an ohm meter. See specifications below:
CONNECT
TEST METER LEADS
TO:
AWD Coil GY to BN/WH
AWD Coil GY to Ground
AWD Hub Coil Resistance:23 Ω ± 5%
3. Verify the wiring harness, wiring, connectors,
connector pins and grounds are undamaged, clean
and connected properly.
4. Verify continuity of wire connections with a volt/ohm
meter.
NOTICE
Verify all wires and wiring connections have been
tested properly with a known good volt/ohm meter
before suspecting a component failure. 80% of all
electrical issues are caused by bad/failed connections
and grounds.
12.20

VEHICLE SPEED SENSOR SERVICE

SPEED SENSOR LOCATION

The speed sensor
transmission, accessed through the right rear wheel well.
OHMS
READING
~ 23 Ω
Open Line (OL)
q
is located on the ride side of the
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.