Cleaning And Maintenance; Cleaning The Filter - Aqualisa Quartz Electric Installation And User Manual

CLEANING AND MAINTENANCE

Your Quartz™ Electric unit should be cleaned using only a soft cloth and washing up
liquid.
DO NOT USE ABRASIVE CLEANERS
To reduce the requirement for chemical descaling in hard water areas, the shower head
incorporates rub clean teats. Any scale build up that may occur in any of the holes can
be broken down by gently rubbing the flexible tips of the jets during use. This procedure
should be completed regularly, as often as once a week in some hard water areas as
scale build up can affect the spray pattern and cause the shower to perform poorly.
Should chemical descaling of the head become necessary, remove the shower head
and fully immerse in a mild proprietary descalent .
!
It is imperative that descaling is carried out in accordance with the
manufacturer's instructions, substances that are not suitable for plastics
•
and electroplated surfaces must not be used. The shower hose and
handset can only be replaced with genuine Aqualisa parts.

Cleaning the Filter

Cleaning the filter should only be completed by a qualified person.
1.
Turn the shower electrical isolating switch off.
2.
Isolate the water supply to the shower.
3.
Carefully remove fixing screws from the top and bottom of the front cover.
Carefully pull the front cover away from the unit ensuring the solenoid
connector block is detached.
4.
Unscrew the two screws on the filter protective cover and
remove the filter assembly.
5.
Remove the filter assembly and clean as necessary.
6.
Refit the filter assembly and protective cover. Reassemble
the unit in reverse of the above procedure.
Fig.2
Fig.2
Inlet Filter
29