Useful Functions - Sharp IG-HH1A Operation Manual

USEFUL
FUNCTIONS
Vertical swing/Direction setting
"Vertical swing ON"
● Swing angle up: 60°; down: 40°
Main unit/Remote controller
Select your favorite airflow
direction
Remote controller
"Vertical swing/Direction setting" and "Horizontal swing/Angle setting"
● Do not adjust the angle of horizontal and vertical swing directly by hand. (A burn or malfunction will be
CAUTION
caused.)
● Do not touch the louver during operation. (Injury, burns or malfunction will be caused.)
● The louver does not move for approximately 10 seconds just after the operation starts.
● The louver may stop working temporarily during horizontal or vertical swing, it's not a malfunction.
● When there is no horizontal swing or louver movement for 20 seconds after starting the operation of
horizontal or vertical swing, please immediately remove the plug from the power outlet, and contact the store
you purchased or Sharp service center.
Horizontal swing/Angle setting
"Horizontal swing ON"
● Horizontal swing starts at an angle of 15°.
Main unit/Remote controller
Remote controller
The center position of horizontal swing
● After inserting the plug (or when power resume after failure), the center position
will be automatically identified when the HORIZONTAL SWING button, ION
MODE button, or FOOT WARMING button is pressed.
● During identification of the center position (approximately 20 seconds), you
cannot set the angle.
● During horizontal swing, the center mark (mark ) of the main unit will be the center position of the swing
operation. During the main unit setting, align mark
● In case of any deviation from the center point, unplug the unit and then plug in again to restart horizontal swing, and
readjust the center point.
IG-HH1A_0607.indd 11
(continued)
Pip
("ON" indicator light flashes)
w The default direction is horizontal.
Pip
Horizontal 40° downward
Pip
Pip
15° 30°
● You cannot change the angle if horizontal swing is not turned on.
● The angle options are fixed.
with the center position of the desired airflow range.
E-11
CAUTION
Do not adjust the louver directly by hand.
[Otherwise, it may cause burns or malfuncion]
"Vertical swing OFF"
● Can be stopped at a desired position.
Main unit/Remote controller
Pip Pip Pip
Horizontal
"Horizontal swing OFF"
● Can be stopped at a desired position.
Main unit/Remote controller
Pip Pip
60° 90°
When determining the center position, the digital display
will change, and the louver will start horizontal swing.
Pip Pip
Pip Pip
40° upward
Pip Pip
Pip Pip
ピピッ
See page E-6
2017/06/13 13:24:17