ABB COM600 Series Operator's Manual page 18

COM605 3.1
18
COM600 Station Automation Series
Operator's Guide
The station and bay local/remote switch must be in a position which allows it to be
controlled with HMI. The target switch device must also support the operation and it
must be configured properly.
To control a switch device (for example circuit breaker), click the object in the single
line diagram. The Switch device control dialog opens.
The Switch state tab displays information on the substation, voltage level and bay under
operation and the object name of the switch device. Also status information for example
on the interlockings and selection state of the object are displayed.
To control a switch:
1. Select the control direction by clicking Open or Close.
2. Click Operate to activate the selection or Cancel to cancel the operation. Note that
some of the buttons may be disabled depending on the state of the switch.
It is possible to perform a forced cancel operation. This is necessary for example if HMI
is accidentally closed after you have activated a selection. Normally the object would
stay in the selected position until timeout, and the object must be released if any operations
have to be performed before timeout. To perform a forced operation, select the Forced
operation tab of the Switch device control dialog and click Cancel.
To add, edit or delete web links, select the Web links tab and click Edit.
To close the Switch device control dialog, click Exit.
1MRS756121