Maintenance - Panasonic MLS-3751 Operating Instructions Manual

High-pressure steam sterilizer
Table of Contents

Advertisement

Maintenance

Before performing maintenance, set the power switch to the
OFF position.
Set the power switch to " OFF " and sufficiently cool
the product before performing maintenance.
Failure to observe this warning may result in electric shock
or burns.
Do not use thinner, benzene, etc. that may give damage to the
product.
Product
Soak soft cloth with water or neutral detergent, squeeze the cloth
well and wipe off dirt.
(Standard frequency of cleaning: Once a month)
Exhaust tank/Exhaust tank at rear side
If the inside of the exhaust tank becomes dirty, pour hot water mixed
with neutral detergent into the tank and shake it well to remove dirt,
and rinse it thoroughly with water.
(Standard frequency of cleaning: Once a month)
Cover packings and chamber opening
Wipe them carefully with soft cloth impregnated water.
Contaminated cover packings and chamber opening may cause
steam leakage.
(Standard frequency of cleaning: Once a day)
Chamber inside
Chamber inside
Wipe the chamber inside with soft cloth impregnated water or
neutral detergent. If it is difficult to get the dirt out of the chamber,
wipe it well with nylon scrubber impregnated with neutral detergent
and then rinse it with running water.
In the case of liquid sterilization, wash away the dirty liquid with
water when it is boiling over.
(Standard frequency of cleaning: Once a month)
After sterilizing culture mediums that generated sulfide gas or
chlorine gas, clean the chamber on the inside without fail.
Corrosion of the chamber may cause premature malfunction
of the product.
(Standard frequency of cleaning: Once a day)
Bottom of chamber inside
Remove the heater cover and wash the bottom carefully by means
of a hand brush paying attention so as not to give damage to the
sensor.
(Standard frequency of cleaning: Once a month)
As for the cleaning of heavy soil, please consult your dealer.
CAUTION
Make sure
of power-OFF.
Cover packing
Chamber opening
Temperature sensor
(Plan of bottom of chamber inside)
Drain port
Heater
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mls-3751lMls-3781Mls-3791l

Table of Contents