Connection System Equipment - Mitsubishi Electric MELSEC iQ-R Series User Manual

5.2

Connection System Equipment

This section shows the equipment that can be connected to the high speed data communication module.
SD memory card (sold separately, required)
The high speed data communication module requires one SD memory card.
Use one of the following SD memory cards manufactured by Mitsubishi Electric.
Model
NZ1MEM-2GBSD
NZ1MEM-4GBSD
NZ1MEM-8GBSD
NZ1MEM-16GBSD
When using an SD memory card, make sure to refer to the considerations. (Page 10 Considerations for using an SD
memory card)
Ethernet (twisted pair) cable (sold separately)
The Ethernet cables compliant with IEEE802.3 1000BASE-T/100BASE-TX/10BASE-T standards can be used.
Transmission speed
1 Gbps
100 Mbps
10 Mbps
When using an Ethernet cable, make sure to refer to the considerations. (Page 61 Wiring Precautions)
Unshielded twisted pair cable (UTP cable)
Shielded twisted pair cable (STP cable)
Straight cable
Category 5e or higher
Category 5 or higher
Category 3 or higher
Capacity
2 GB
4 GB
8 GB
16 GB
Crossing cable
Category 5e
Category 5 or 5e
Category 3 to 5e
5 SYSTEM CONFIGURATION
5.2 Connection System Equipment
5
57