Storage - Toro MB TX 2500 Operator's Manual

Storage

1. Engage the parking brake, shut off the engine,
and remove the key.
2. Remove dirt and grime from the external parts of
the entire machine, especially the engine. Clean
dirt and chaff from the outside of the engine
cylinder head fins and blower housing.
3. Service the air cleaner; refer to
Cleaner (page 19).
4. Grease the machine; refer to
Machine (page 19).
5. Change the engine crankcase oil; refer to
Changing the Engine Oil and Filter (page
6. For storage over 30 days, prepare the machine
as follows:
A. Add a petroleum-based fuel
stabilizer/conditioner to the fuel in the
tank. Do not use an alcohol-based
stabilizer (ethanol or methanol).
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank using a pump-type
syphon.
D. Start the engine and run it until it shuts off.
E. Choke the engine.
F. Start and run the engine until it does not
start again.
G. Dispose of fuel properly. Recycle as per
local codes.
Important:
Do not store fuel containing
stabilizer/conditioner longer than the
duration recommended by the fuel-stabilizer
manufacturer.
7. Remove the spark plugs and check the condition
of them; refer to Checking the Spark Plug (page
23).
8. Prepare the engine as follows:
A. With the spark plugs removed from the
engine, pour 2 tablespoons of engine oil
into the spark plug holes.
B. Place a rag over the spark plug holes to
catch any oil spray, then turn the key to
crank the engine and distribute the oil inside
the cylinder.
C. Install the spark plugs.
Note:
Do not install the wire on the spark
plugs.
10.
11.
12.
Servicing the Air
Greasing the
21).
38
9. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
Store the machine in a clean, dry garage or
storage area.
Cover the machine to protect it and keep it clean.