Toro 25430 Operator's Manual page 31

Note: If you do not have a rigid drawbar, use 2 towing
machines. Attach a tow chain each to the front and rear
towing machines. Use the front towing machine to move the
non-functioning machine and the rear towing machine to
stop the non-functioning machine.
Note: This machine has hydrostatic braking. When you stop
the engine, the brakes automatically engage.
1. Disconnect the hydraulic hose from the parking brake
cylinder as shown in Figure 30.
1. Parking brake cylinder
hydraulic fitting
2. Hydraulic brake hose
2. Connect a hydraulic-hand pump capable of producing
350 psi to the brake cylinder (Figure 30).
3. Operate the hand pump until the brakes are released.
4. Move the utility-traction lever to the Neutral position.
Note: You can move the machine up to 8 km/h (5
mph) and a distance up to 1.6 km (1 mile) away. To
transport a disabled machine more than 1.6 km (1 mile),
you must use a suitable trailer; refer to Transporting the
Machine (page 30).
5. Tow the machine to the transport vehicle or to a site
where you can repair the machine.
Figure 30
3. Hand pump fitting
connected to the cylinder
fitting
4. Hand pump
6. Disconnect the hand pump and connect the hose
to the parking brake cylinder before transporting or
making any repairs.
31