Greasing And Lubricating The Tractor; Checking The Tire Pressure - Toro 71233 Operator's Manual

Adjusting the Brake
1. Check the brake before you adjust it; refer to Checking
the Brake on page 22.
2. Remove the brake arm spring (Fig. 21).
3. Remove the cotter pin that secures the brake adjusting
nut and slightly loosen the nut (Fig. 21).
4. Insert a 0.015 in. (0.38 mm) feeler gauge between the
brake disc and the brake puck (Fig. 21).
5. Tighten the nut until you feel a slight resistance on the
feeler gauge when you slide it in and out.
6. Install a new cotter pin and attach the brake arm spring.
7. Check the brake operation again; refer to Checking the
Brake, page 22.
Important With the parking brake released, the rear
wheels should rotate freely when you push the tractor. If
you cannot set the 0.015 in. (0.38 mm) clearance and get
free wheel rotation, contact an Authorized Service Dealer
immediately.
Greasing and Lubricating the
Tractor
Grease the tractor after every 25 operating hours or once a
year, whichever occurs first. Grease more frequently when
operating conditions are extremely dusty or sandy.
Grease Type: General-purpose grease
How to Grease
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Clean the grease fittings with a rag.
6. Scrape any paint off of the front of the fittings.
7. Connect a grease gun to the fitting and pump grease
into the fittings.
8. Wipe up any excess grease.
Where to Add Grease
Lubricate the front wheels and steering spindles until
grease begins to ooze out of the bearings (Fig. 22).

Checking the Tire Pressure

Maintain the air pressure in the front and rear tires at 20 psi
(138 kPa). Check the pressure at the valve stem after every
25 operating hours or yearly, whichever occurs first
(Fig. 23). Check the tires when they are cold to get the most
accurate pressure reading.
1. Valve stem
23
m-2346
Figure 22
1
m-1872
Figure 23