Toro 41177 Operator's Manual page 31

so may cause the chemicals to dry or thicken in the
lines, clogging the pump and other components.
Clean the spray system after each spraying session. To
properly clean the spray system:
• Use three separate rinses.
• Use a minimum of 50 gallons for each rinse.
• Use the cleaners and neutralizers as recommended
by the chemical manufacturers.
• Use pure clean water (no cleaners or neutralizers)
for the last rinse.
The rinse tank is located at the front, right side of the
chemical tank (Figure 26). If you install the optional
Rinse Kit, you can fill this tank with fresh water and
automatically rinse the main tank, boom supply lines
and nozzles.
Figure 26
1. Rinse tank (for use with the optional rinse kit, 106-4842)
1. Stop the sprayer, set the parking brake, place the
range selector in the Neutral position, and turn off
the engine. The tank will drain to left side of the
machine.
2. Locate the tank drain valve on the left side of the
machine (Figure 27). The valve is on the frame in
front of the fuel tank.
1. Tank drain handle
Open the valve to drain any unused material
from the tank and dispose of it according to local
codes and the material manufacturer's instructions
(Figure 28). After draining, remove the lynch pin on
the bracket securing the drain valve to the machine
and let the valve rest on the ground . This allows
any residual material in the line to drain.
1. Valve open
2. Lynch pin
31
Figure 27
2
G005482
Figure 28
3. Valve closed
3
1