Table of Contents
Advertisement
Voltmeter
The voltmeter (Figure 15) indicates the level of charge
in the battery. When the battery is fully charged, the
voltmeter will read in the center of the dial when the
key is in the Run position with the engine off. When
the engine is running the voltmeter needle should be
to the right.
Headlight Switch
Toggle the switch to operate the headlights (Figure 15).
Push it forward to turn the lights on and rearward to
turn them off.
Neutral Engine Speed Lock Switch
When the range selector is in the Neutral position, you
can use the accelerator pedal to speed up the engine,
then push this switch forward to set the engine at that
speed. This is necessary to run the chemical agitation
while stationary or operating attachments such as the
hand sprayer (Figure 15).
Important: The range selector must be in the
neutral position for the switch to work.
Fuel Gauge
The fuel gauge is located on top of the fuel tank, on
the right side of the machine and shows the amount of
fuel in the tank.
Master Boom Switch
The master boom switch is located on the floor board
of the machine cab and to the left of the operator. It
allows you to start or stop the spray operation. Press
the switch with your foot to enable or disable the spray
system (Figure 16). When the master switch is off, the
Spray Pro monitor screen reads "Hold."
Figure 16
1. Master boom switch
Boom Switches
The boom switches are located at the front of the
control panel to the right of the seat (Figure 17). Toggle
each switch forward to turn the corresponding boom
section on and rearward to turn them off. When the
switch is turned on, a light on the switch illuminates.
These switches will only affect the spray system when
the master boom switch is on.
1. Boom switches, left, right
and center
2. Pump switch
3. Rate lockout key
4. Application rate switch
Pump Switch
The pump switch is located on the control panel to the
right of the seat (Figure 17). Toggle this switch forward
to run the pump or rearward to stop the pump.
Important: Only engage the pump switch when
the engine is at low idle to avoid damaging the
pump drive.
Application Rate Switch
The application rate switch is located on the control
panel to the right of the seat (Figure 17). Press and hold
the switch forward to increase the spray system pressure,
or press and hold it rearward to decrease pressure.
20
Figure 17
5. Boom lift switch, left and
right
6. Sonic boom switch
7. Foam marker switch, left
and right
Advertisement
Table of Contents
