Table of Contents
Advertisement
network connection and setup
2. Click [manual Set].
The Manual Setting dialog appears.
<ip address>, <Subnet mask>, <Gateway>, <Http port>, and <vnp port> of
the camera are displayed in the preset values.
3. In the <address> pane, provide the
necessary information.
• MAC (Ethernet) Address : The MAC
address imprinted on the camera
label is automatically displayed and
requires no user setting.
IP related parameters can be set only
`
M
when DHCP is not checked.
if not using a Broadband router
For setting <ip address>, <Subnet mask>, and <Gateway>, contact your network
administrator.
4. In the <port> pane, provide necessary
information.
• HTTP Port : Used to access the
camera using the Internet browser,
defaulted to 80.
• VNP Port : Used to control the video
signal transfer, defaulted to 4520.
5. Enter the password.
Enter the password of "admin" account, which was used to access the camera.
For the security purposes, you are recommended to use a combination of numbers, alphabets
`
J
uppercase and lowercase and special characters for your password.
If you want to change the password, refer to "Administrator password change" of the user
`
setup. (page 104)
6. Click [oK].
Manual network setup will be completed.
30_ network connection and setup
Advertisement
Table of Contents
