Table of Contents
Advertisement
overview
rear of the main unit
Item
Power supply
a
terminal
Network connection
b
terminal
In/out terminal
c
Reset Button
d
Power indicators
e
14_ overview
a
b
NETWORK
LINK
ACT
DC 12V
Terminal used to connect to the DC12V power adaptor.
Terminal used to connect to PoE or LAN via the RJ-45 cable.
GND
ALARM OUT
ALARM IN
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
POWER
c
d e
4 3 2 1
RESET POWER
GND : 1, 2
ALARM OUT : 3
ALARM IN : 4
Description
Ground terminal.
Terminal to connect the alarm output signal.
Terminal to connect the alarm input signal.
ON : While the power is on
OFF : If the power is off
Advertisement
Table of Contents
