Panasonic CF-74ECBGDBM Service Manual page 37

9.2.8. Setting the DC-IN PCB and I/O PCB
1. Fit the Modem Cable and LAN Cable between the MOD-
ELAN Holders, and set them on to the computer.
2. Fix the I/O PCB to the I/O Plate using the four
Screws<N19>.
3. Fix the I/O PCB with I/O Plate to the computer using the
two Screws<N9>.
4. Fix the DC-IN PCB to the computer using the two
Screws<N9>.
Screws <N9>: DFHE5025XA
Screws <N19>: DFHE5035ZB
Arranging the DC-IN Cable
DC-IN PCB
Safety Working
Set the Core of the Modem
over the DC-IN Cable.
FAN Cable Sheet
Safety Working
Fix the Core using the Tape.
DC-IN Cable
0~3mm
0~3mm
Avoid runnning over the boss.
(Otherwise the Cable will be caught
at the Bottom Cabnet.)
Fold back the end of Tape.
Modem Cable
DC-IN PCB
<N9>
MODELAN-2
Holder
Turn the DC-IN Cable halfway
(counterclockwise)
Attach the Cable avoiding
overlapping
(DC-IN Cable and INV Cable).
Set the INV Cable under
the DC IN Cable.
9-15
LAN Cable MODELAN
Holder
<N19>
<N9>
I/O PCB
I/O Plate
Connect the Connector
INV. Cable
Safety Working