Table of Contents
Advertisement
9.2.6.
Setting the USB PCB
1. Fix the USB PCB to the computer using the two
Screws<N9>.
2. Connect the USB Cable to the Connector (CN1701).
Screws <N9>: DFHE5025XA
Arranging the USB Cable
Safety Working
Connect
the Connector.
Pass it through
the notch.
MP Slide Sheet
Attach the MP Slid Sheet to prevent the Cable from coming off.
USB Cable
Tape
Ensure the Cable does not
come out of the board edge
Pass it through
so that the Cable does not
the notch.
touch the MP Drive.
Avoid runnning over the boss.
MP Slide Sheet
<N9>
Fitting edge
Pass the Cable through
the notch and lead it downward.
Pass it through the rib.
Ensure the "A" end does not come on the level.
9-13
CN1701
USB PCB
A
Fit the surplus length of
the Cable into this side.
Fit the Cable between the pins.
Advertisement
Table of Contents
