Table of Contents
Advertisement
6. Using the dimensions shown in
and drill a 1.03 cm (.406 inch) diameter hole in the right
front corner of the cutting unit.
Figure 6
1. 3.2 cm (1.25 inch)
2. 10.1 cm (4.00 inch)
7. Mount the discharge shelf to the front and underside
of the cutting unit with 2 carriage bolts (3/8 x 1 inch)
and 3/8 inch flange nuts. Position the baffle as shown
in
Figure 7 andFigure
8. Mount the new front baffle to the underside of the
cutting unit with 3 capscrews (3/8 x 1 inch), 3 washers,
3/8 x 1 inch carriage bolt and 4 flange nuts (3/8 inch).
Position the baffle as shown in
9. Mount the new rear baffle to the underside of the
cutting unit with 2 capscrews (3/8 x 1 inch) and 3/8
inch flange nuts. Position the baffle as shown in
7
and
Figure
8.
Figure
6, locate, mark
3. 1.03 cm (.406 inch
diameter)
8.
Figure 7
and
Figure
1. Discharge shelf
2. Rear baffle
8.
Figure
1. Discharge shelf
2. Rear baffle
10. Using a 1/2 inch ratchet, torque wrench or similar
tool, move the idler pulley away from the drive belt to
release the belt tension and allow the belt to be slipped
off the right spindle pulley
9
Figure 7
3. Front baffle
4. Carriage bolt
Figure 8
3. Front baffle
(Figure
9).
Advertisement
Table of Contents
