Placing Outgoing Calls From Single Line Telephones - NEC DS1000 Quick Setup Manual

2. Enter
1003: TRUNK OPTION
TRUNK PORT?n
3. Enter the number of the trunk you want to program (e.g., 1) +
1003:TRUNK PORT?:1
PICK-UP Group?n
4. Press
1003:TRUNK PORT?:1
DAY TERM?KEY RING
5. Enter the Ring Group master number (e.g., 600) +
6. Press
Press
Part III: Assign Single Line Sets to the Ring Group
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1802:EXT OPT PART 1
STATION #?nnn
3. Enter the number of the single line extension you want to program (e.g., 319) +
1802:STA:nnn
ALLOW DND?YES
4. Press
1802:STA:nnn
RING GROUP NUM?n
5. Enter the Ring Group number (e.g., 1) you assigned in Step I above +
6. Press
Press

Placing Outgoing Calls from Single Line Telephones

With DS1000 software version 02.02.00 and higher, single line telephone users can dial 9 for an outside
line by default.
If your single line telephone users can't dial 9 to place outgoing calls, you need to check the following:
Part I: Assign some trunks to Trunk Group 0 (which is the default dial 9 group).
Part II: Allow analog ports to have full or outgoing access to the trunks in group 0.
Part I: Assign Trunks to Trunk Group 0.
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1002:TRUNK GROUPS
TRUNK GROUP?0
3. Press
1002:TRUNK GROUP:0
ORDR 1:TRK NUM?UND
4. Dial
1002:TRUNK GROUP:0
ORDR 2:TRK NUM?UND
DS1000/2000 Quick Setup Guide
1003 + HOLD . You see:
Vol Up until you see:
CONF to go back to step 3 and enter another trunk number.
OR
CONF twice to exit program 1003.
1802 + HOLD . You see:
Vol Up , you see:
CONF to go back to step 3 and enter another trunk number.
OR
CONF twice to exit program 1003.
+ . You see:
1002 HOLD
HOLD to select Trunk Group 0. You see:
1 and press Vol Up . (This assigns trunk 1 as your first outgoing trunk in group 0.) You see:
Section 1: Start-up Programming
HOLD
HOLD .
Section 1: Start-up Programming
. You see:
HOLD . You see:
HOLD .
1
1-9