Changing Ringing Assignments With User Programmable Features; Placing Outgoing Calls From Single Line Telephones - NEC DS1000 Quick Setup Manual

Section 1: Start-up Programming
4. Enter the number of the trunk you want to program (e.g., 1) + HOLD . You see:
1805:EXT:nnn LINE:n
nnnnnnn
5. For the extension and trunk selected, enter the ring option + CONF :
1 = Lamp only (no ringing)
2 = Ringing day and night
3 = Ringing at night, lamp only during the day
4 = Delayed ringing day and night
1805:EXT:nnn
LINE NUMBER?n
6. Go back to step 4 and enter the number of another trunk to program for the selected extension.
Press CONF and go back to step 3 to select another extension.
Press CONF twice to exit program 1805.

Changing Ringing Assignments With User Programmable Features

A keyset user can change line key ringing right from their phone.
To change line key ringing with the User Programmable Features:
1. Dial #RAL .
2. Press the line key to change its ringing mode.
3. Press SPK when you are done.
See User Programmable Features on page 1-18 for more.

Placing Outgoing Calls from Single Line Telephones

By default, single line telephone users can dial 9 for an outside line.
If your single line telephone users can't dial 9 to place outgoing calls, you need to check the following:
● Part I: Assign some trunks to Trunk Group 90 (which is the default dial 9 group).
● Part II: Allow analog ports to have full or outgoing access to the trunks in group 90.
Part I: Assign Trunks to Trunk Group 90.
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1002 + HOLD . You see:
1002:TRUNK GROUPS
TRUNK GROUP?90
3. Press HOLD to select Trunk Group 90. You see:
1002:TRUNK GROUP:90
ORDR 1:TRK NUM?UND
4. Dial 1 and press VOL Up . (This assigns trunk 1 as your first outgoing trunk in group 90.) You see:
1002:TRUNK GROUP:90
ORDR 2:TRK NUM?UND
1-8 ◆ Section 1: Start-up Programming
The currently programmed ringing option for the trunk selected displays.
OR
OR
Your line keys flash. The flash rate shows the type of ringing enabled:
On red = lamp only day and night
On green = immediate ring day and night
Fast flash green = delay ring day and night
Slow flash green = immediate ring at night, lamp only during the day
DS1000/2000 Quick Setup Guide