Operation panel
A: Turns "on"/"off" the
power
[MENU]: Displays the menu
Main Unit - Input Terminals
A
A [3D SYNCHRO] terminal
By connecting a 3D Synchro Emitter (sold separately)
to this terminal, you can view 3D movies.
B [HDMI 1] input terminal
C [HDMI 2] input terminal
For connecting to devices that support HDMI output.
(P. 19)
It is fitted to the M3 lock hole. The depth of the screw
hole is 3 mm (0.1 in).
D [RS-232C] terminal (D-sub 9-pin
male)
The projector can be controlled by connecting a PC to
this terminal.
12
B
C
E [SERVICE] terminal
F [LAN] terminal (RJ-45)
G [TRIGGER] terminal
[J INPUT K]: Switches the input
[BACK]: Returns to the previous menu
[OK]: Confirms a selection
[JKH I] keys: Selects an item
D
E
For updating the software using a commercially
available USB flash drive.
The projector can be controlled by connecting it to a
PC through the computer network for control
commands to be sent to the projector.
Output terminal for DC 12 V, 100 mA power supply. It
is used for sending output signals to control devices
such as an elevating screen that is equipped with a
trigger function.
Note that improper connection may damage the
projector. (Tip=DC +12 V, Sleeve=GND)
F
G