Huawei Airbridge cBTS3612 Maintenance Manual page 22

On-site Maintenance Manual
Airbridge cBTS3612 CDMA Base Station
III.
Check if the cell has obtained the BSC logical
configuration
1) If the cell has not obtained the logic configuration, i.e.
common channels for pilot frequency, synchronization, paging
common channels, etc. has not been established or an overhead
message update has not been performed, the MS will of course not
be able to connect to the network.
Check the configuration progress report for this cell in the "BTS
status" window on the OMC console: if there is no such progress
reports as "Common
"Overhead message updated successfully", that means the logic
configuration for this cell has not completed.
2) Sometimes the unavailability of certain physical equipment,
or some operation mistakes (such as deleting a device by mistake)
will result in the cell being deleted and the MS being unable to
connect to the network.
Check the configuration progress report for this cell in the "BTS
status" window on the OMC console: if there is a progress report
saying "Cell deleted", that means the cell has been deleted.
If the cell has not obtained the logic configuration, we need to
verify the following items by checking the relevant indicators, board
status and alarm messages, etc.:
Whether the BTRM used in this cell is working properly;
l
Whether the BCPM used in this cell is working properly;
l
Whether the corresponding BRDM is working properly;
l
channel established
2-3
Chapter 2 General Fault
Processing
successfully" and