Programming - ABB 6136/30M-500 Operating Instructions Manual

ENG
9.2

Programming

Call up "Commissioning" in the "System"
menu.
• See chapter "System settings".
• You may now program the unit using an
SD-/MMC card or via the bus.
Programming via the bus may take several hours, depending on the configuration. Use
bus progamming only for minor project changes!
We recommend programming with an SD/MMC card!
Programmi 1. Create the new project with the
ng with commissioning software on a PC and
SD/MMC save the project on an SD/MMC card.
card
2. Insert the SD card into the room/control
panel and press the "Read
Multimedia/SD card" button (Fig. 68).
44
Fig. 67
Fig. 68