Yamaha DRIVE 2 SUPER HAULER 2019 Owner's/Operator's Manual page 43

Under normal charge circumstances, the LEDs operate as follows:
To reset charger after 100% charge (Green LED), disconnect the DC plug
from battery for more than 30 seconds. Then, reconnect DC plug.
J2F
Ammeter On:
(Amber)
Blinking:
80% Charge On:
(Amber)
Blinking:
100% Charge On:
(Green)
Blinking:
AC On On:
(Amber)
Blinking:
Fault Blinking:
(Red)
MAINTENANCE
Displays
approximate scale
of current output
during Step 2.
High internal
charger
temperature.
Current output
reduced.
80% charged, Step
2 complete. Begin
Step 3.
With no battery
connected,
indicates algorithm
# selected by
number of flashes
at startup.
Charging
complete.
Charger in
Storage Mode.
Step 3 complete.
Begin Step 4.
AC power good.
Charger may be
overheated.
Move charger to
cooler location.
Charger error.
Refer to
Troubleshooting
on next page.
8
Y-1679
8-15