• If your traction unit has tires and you have the
agricultural or Sitework Systems tires installed on the
traction unit, remove the tires and move the right side
Maintenance
Service Interval Chart
Service Operation
Grease pivot pin fittings
Gear lube oil—check level
Gear lube oil—change
Chipped surfaces—paint
POTENTIAL HAZARD
• If you leave the key in the ignition switch, someone could start the engine.
WHAT CAN HAPPEN
• Accidental starting of the engine could seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
• Remove the key from the ignition switch before you do any maintenance.
Greasing
Service Interval/Specification
Grease 6 fittings, as shown in Figures 8 through 11, every
8 operating hours. Grease all fittings immediately after
every washing.
Grease Type: General-purpose grease.
Fitting Locations
Figure 8
tires to the left and the left side tires to the right. This
will ensure that the tire tread points to the rear to give
you the most traction when using the vibratory plow.
Each
5
25
Use
Hours
Hours
X
X
CAUTION
m–4146
8
200
Storage
Hours
Service
X
X
X
Figure 9
Notes
m–4148