Advertisement
3. spEcification
output Voltage: ...........................................................12/24V
output Charge Peak (en) ....................................... 75A(50A)
output Start Peak (en) ....................................... 400A(300A)
Battery Range ...........................................................4-550Ah
Input Charge ............................................................... 1.5KW
Input Start .................................................................... 10KW
Charging Rates ........... 3xPreset+1XVariable to Current max.
Supply .......................................................230V 1ph 50/60Hz
BSu ...................................................................... 30A-13.5V
Polarity Protection ...........................................Fuse (2x100A)
Fuse .....................................................................eCS400.20
4. assEmBly
4.1.
Carefully unpack all components and prepare a surface on which you can lay the unit down on during assembly, without damaging it.
4.2.
Insert the handle (fig.1.1) and secure it through the rear of the unit with screws (fig.1.2).
4.3.
Screw on the clamp holders to each side (fig.1.3).
4.4.
Use the long screws to screw on the cable retainers and spacers on each side (fig.1.4).
4.5.
Lay the unit on its front in order to insert the axle. Fit the wheels (fig.1.5), then their retainers and caps (fig.1.6).
4.6.
Clamp Assembly (fig.2).
4.6.1.
Push cable through insulating handles.
4.6.2.
locate cable using cable screw washer and nut, note which way up cable needs to be. Screw on cable clamp tightly.
4.6.3.
Screw up cable screw tightly.
4.6.4.
Push outer protection pieces onto the ends of the clamp.
4.6.5.
Slide insulating handles up to meet the outer protection pieces.
4.6.6.
Repeat for all four clamps.
data Plate
© Jack Sealey limited
fig.1
Original Language Version
fig.2
eCS400 | Issue 2 (H13F) 20/04/18
Advertisement
