Warning Icons And Error Codes - Philips EP5065 User Manual

2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine
back on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding
ground coffee.
Note: If the descaling procedure was not completed, the machine will require another descaling
procedure as soon as possible.

Warning icons and error codes

Meaning of the warning icons
Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee
grounds container.
Meaning of error codes
Below you find a list of the error codes showing problems that you can solve yourself. Video
instructions are available on www.philips.com/coffee-care. If another error code appears, please
contact the Philips Consumer Care Center in your country. For contact details, see the warranty leaflet.
Error Problem
code
01 The coffee funnel is
blocked by ground
coffee or a foreign
object.
Possible solution
Switch off the machine and unplug it. Remove the brew group.
Then open the lid of the pre-ground coffee compartment.
Insert the spoon handle and move it up and down to make
clogged ground coffee fal down (Fig. 29). If a foreign object is
blocking the coffee funnel, remove it. Visit
www.philips.com/coffee-care for detailed video instructions
English
The brew group is blocked by
coffee powder. Clean the brew
group.
Insert the drip tray and close
the service door.
If the display shows an error
10
code, check section 'Meaning
of the error codes' to see what
the code on the display means
xx
and what you can do. The
machine cannot be used when
this icon is on the display.
There is air is the machine,
place a cup under the hot
water spout and select Ok to
start priming. Make sure the
hot water spout is inserted
before starting the process.
17