Stirring Unit; Main Unit/Control Panel/Temperature Sensor/Thermo Plate/Power Cord - Sharp Healsio KN-H24VNA Operation Manual

CARE AND CLEANING

Stirring unit

Clean after every use.
●
Wash with mild soap or detergent solution
●
using a soft sponge. Rinse and dry thoroughly.
Remove the stirring unit when cooking a dish which does not require it - this makes cleaning it easy.
How to attach
❶
Push the stopper (square side) until it clicks,
and the stopper (round side) on the opposite
side will come out.
Stopper (square side)
Stopper
(round side)
Attachment
shaft
❷
Insert the
attachment shaft
in the stirring unit
attachment hole.
Stirring unit
attachment hole
❸
Push the stopper (round side) until it clicks.
The opposite side stopper (square) side will
come out, and the unit will be firmly attached.
Push to lock the unit in place.
After locking the unit
in place, try to pull it
away from the lid to
make sure it does not
move.

Main unit/Control panel/Temperature sensor/Thermo plate/Power cord

Clean when dirty. Wipe with a soft cloth dampened with water only.
*Remove ingrained dirt from the thermo plate lightly with sandpaper (about 600-Grit) and wipe with a soft cloth
dampened with water only.
continued
Removing the unit
Push the stopper (square side) and the unit will
come free.
Align the
match marks.
Cleaning tips
❶
❷
Click
For heavy dirt, soak the stirring unit in water with
mild detergent solution. That will make it easier to
remove the dirt
(Soak the stirring unit without removing the cover)
en-19
Dry the unit carefully after cleaning,
and assemble it in reverse order as
it is removed.
Gently open the stirring wings and remove dirt.
Open the clips on each side and remove
the cover. Remove dirt.
Cover
Stirring wings
Clips