Table of Contents
Advertisement
2-4
Figure 2.1
ServeRAID M5110 Controller Installation in a
PCI Express Slot
Press
Here
Edge of
Motherboard
Step 6. Connect the Controller to the Drive Backplane on an Enclosure
Use cables to connect the controller to the drive backplane of
an enclosure that contains SAS devices, SATA devices, or both.
Refer to
Section 2.4, "Connecting a ServeRAID-M5110
SAS/SATA Controller to a Drive Backplane on an Enclosure"
details about connecting the controller to the enclosure.
Step 7. Turn on the Power to the System
Reinstall the computer cover and reconnect the AC power
cords; then, turn on the power to the computer.
Make sure that the power is turned on to the SAS devices and
the SATA III devices before or at the same time as the host
computer. If the power is turned on to the computer before it is
ServeRAID Controller Hardware Installation
Bracket
Screw
Press
Here
PCI Express
3_00793-00
for
Advertisement
Table of Contents
