Table of Contents
Advertisement
turned on to the devices, the computer might not recognize the
devices.
For the United Extensible Firmware Interface (UEFI), no BIOS
message displays. Press F1 to enter System Setup. Refer to
your system user's guide for specific configuration information.
Under other interfaces or operating systems, a BIOS message
appears during boot. The firmware takes several seconds to
initialize. The configuration utility prompt times out after several
seconds. The second portion of the BIOS message displays the
controller number, firmware version, and cache SDRAM size.
The numbering of the controller follows the PCI slot scanning
order used by the host mainboard.
Step 8. Run the WebBIOS Configuration Utility
Run the WebBIOS Configuration Utility to configure the physical
arrays and the logical drives. When the message Press
<Ctrl><H> for WebBIOS appears on the screen, press
CTRL+H immediately to run the utility.
Step 9. Install the Operating System Driver
The controller can operate under various operating systems. To
operate under these operating systems, you must install the
software drivers. You can find and download the latest drivers
at http://www.ibm.com/support/. For updates, click Downloads
and drivers.
Device driver updates are made available periodically. To
ensure that you have the current version of the driver, download
the latest driver at http://www.ibm.com/support/. See the
readme file that accompanies the driver for any updated
information.
For details on installing the driver, refer to the ServeRAID-M
Device Driver Installation User's Guide on the ServeRAID M
Documentation CD. Be sure to use the latest Service Packs
provided by the operating system manufacturer and to review
the readme file that accompanies the driver.
Detailed Installation
2-5
Advertisement
Table of Contents
