Reset The Cable Modem Configuration Settings; Reboot The Cable Modem; Exit The Sb8200 Web Manager - Arris SURFboard SB8200 User Manual
Docsis 3.1
Hide thumbs
Also See for SURFboard SB8200:
- Quick start manual ,
- User manual (29 pages) ,
- Quick start card (2 pages)
Table of Contents
Advertisement
Reset the Cable Modem Configuration Settings
You can restore the factory default configuration settings on your SB8200. This process will
delete the current SB8200 configuration settings and take approximately five to 30 minutes to
complete. Your network connection will remain disabled until after the SB8200 configuration
settings are restored.
WARNING! This process will delete the current SB8200 configuration and replace it with
the factory default settings.
To restore the factory default settings on your SB8200:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset
opening on the back of your SB8200.
2. Press and hold the Reset button for 10 seconds or until the front panel LEDs flash.
3. Remove the paper clip or small object from the Reset opening .
Reboot the Cable Modem
To restart your SB8200:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset
opening on the back of your SB8200.
2. Press and hold the indented Reset button for three to four seconds only, and then release.
WARNING! If you press the Reset button for more than seven seconds, the cable
modem configuration settings will be reset to the factory default settings.
Exit the SB8200 Web Manager
To exit the SB8200 Web Manager:
Click
PN 365-095-30000 x.2
Copyright 2016 ARRIS Enterprises, LLC. All rights reserved.
Chapter 6: Monitoring Your Cable Modem and Connected Network
Figure 13: SB8200 Configuration Screen
Close button) in the upper right corner of the web browser window.
(
SURFboard SB8200 Cable Modem User Guide
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SURFboard SB8200 and is the answer not in the manual?
Questions and answers
Can I set up a 5 ghz and a 2.4 ghz network in my house with this product?
Where do I connect my router to the modem?
Connect the router to the Arris SURFboard SB8200 modem using an Ethernet cable. Plug one end of the cable into the modem's Ethernet port and the other end into the router's WAN (Internet) port.
This answer is automatically generated
Just purchased a new arris surfboard sb8200. The unit is all plugged in. the top 3 lights come on. The 4th light (the internet light) shows a steady flashing. it never turns off. I've waited and waited. It never turns off. I have no tv service or computer or phone service. How long is a reasonable length of time for the 4th light to continue flashing?
During startup, all four LEDs on the Arris SURFboard SB8200 will flash and then light up solid in sequence. The exact duration of flashing is not specified.
This answer is automatically generated