Installing The Upper Handle - Toro power max 828 OE Operator's Manual

1. Installing the Upper Handle

4 Handle bolts
4 Curved washers
4 Locknuts
Procedure
Note: Do not remove the rubber band on the cables
until you have installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables are not pinched between
the handle sections.
1. Cables
2. Secure the upper handle with 4 handle bolts,
4 curved washers, and 4 locknuts from the loose
parts bag (Figure 4).
Figure 3
Figure 4
2. Installing the Traction
Control Linkage
Procedure
1. Remove the hairpin cotter and washer from the
lower end of the speed control rod and insert the
lower end of the rod into the lower link arm so that
the bent end of the speed control rod faces rearward
(Figure 5).
2. Secure the lower end of the speed control rod with
the washer and hairpin cotter that you previously
removed.
3. Remove the hairpin cotter and the outer washer
from the trunnion on the upper end of the speed
control rod (Figure 6).
1. Speed selector lever
2. Trunnion
Note: To make installation easier, leave the flat
washer on the trunnion (Figure 6).
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 7).
7
Figure 5
Figure 6
3. Inner washer
4. Outer washer