Toro power max 828 OE Operator's Manual page 15

down, freeing your right hand. To release both
levers, simply release the left hand (traction)
lever.
3. If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not operate
the snowthrower. Check the auger/impeller cable
(refer to Checking and Adjusting the Auger/Impeller
Cable) and adjust it if necessary. Otherwise, take the
snowthrower to an Authorized Dealer for service.
If the auger and impeller continue to rotate
when you release the auger/impeller lever, you
could seriously injure yourself or others.
Do not operate the snowthrower. Take it to an
Authorized Service Dealer for service.
Operating the Quick Stick™
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute and
chute deflector into position (Figure 30).
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the left;
move the Quick Stick to the right to move the discharge
chute to the right (Figure 31).
Figure 30
• If the chute does not move, refer to Adjusting the
Discharge Chute Latch.
• If the chute does not turn as far to the left as it does
to the right, ensure that the cable is routed to the
inside of the handles. Refer to Installing the Upper
Handle.
• If the chute does not lock into place when you release
the trigger cap, refer to Adjusting the Discharge
Chute Latch.
Moving the Chute Deflector
Hold the blue trigger cap down and move the Quick
Stick forward to lower the chute deflector; move it
rearward to raise the chute deflector (Figure 32).
15
Figure 31
Figure 32