Panasonic DMR-HWT260 Operating Instructions Manual page 69

Messages on the front panel display
The following messages or service numbers appear on the
front panel display when something unusual is detected.
CONV
Selected titles in the USB HDD are being converted.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
PLEASE WAIT
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
PROG FULL
There are already 32 timer programmes. Delete unnecessary
timer programmes. ( 26)
REMOVE
The USB device is drawing too much power. Remove the
USB device.
SET
("∑" stands for a number.)
The remote control and main unit are using different codes.
Change the code on the remote control. (
START
Update of the software (firmware) is started. You cannot
operate the unit until the update is complete. (
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. ( 54)
When "FINISH" is displayed, update of the software
(firmware) has completed.
UNSUPPORT
The media is not supported.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated. You cannot
operate the unit until the update is complete. (
U50
An error has occurerd in the antenna's power supply. Check
to see if the antenna's cable core and braided wire shield are
in contact with each other.
U59
The unit is hot. The unit switches to standby for safety
reasons. Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
U61
A malfunction has occurred. The unit is trying to restore to the
normal operation. Once the message disappears you can use
the unit again. If it remains displayed, consult the dealer.
U76
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
U99
The unit fails to operate properly. Press [Í/I] on the main unit
65)
to switch the unit to standby mode. Now press [Í/I] on the
main unit again to turn the unit on.
X HOLD
54)
The HOLD function is activated. (
54)
56)
69
SQT1332